Hitch Assembly - Yetter 3400 Series Operator's Manual

ATTACHING ROTARY HOE TO TRACTOR

HITCH ASSEMBLY

The rotary hoe is shipped with mast and hitch pin bushings assembled for CAT III or IV hitches.
Remove bushings as required of your tractor.
Place sleeves and spacers in position to fit your hitch. The lower hitch plates are adjustable to fit your
tractor's spacing.
CAUTION:
SURE HITCH PINS ARE COMPLETELY ASSEMBLED TO MATCH YOUR
TRACTOR HITCH.
TRACTOR WITHOUT QUICK COUPLER:
Attach rotary hoe to tractor with draft links to lower hitches.
Adjust the center link or extend the draft links to make hookup easier. Raise parking stand and place
in upper position.
TRACTOR WITH QUICK COUPLER:
Lower the 3-point hitch so the upper jaw of the Quick Coupler passes under the
spacer between the hoe mast plates. This allows lower jaws to pass under the hoe
hitch pins. Back tractor up until coupler jaws are under their respective pins and raise
hitch.
CAUTION: MAKE CERTAIN THAT CENTER LINK AND QUICK COUPLER
ARE LOCKED AND LOCK PINS ARE PROPERLY INSTALLED BEFORE
MOVING ROTARY HOE.
BEFORE ATTACHING ROTARY HOE TO TRACTOR, BE
15