Operation; General - probst HVZ-ECO Operating Instructions Manual

Hydraulic installation clamps for universal use with excavators
Hide thumbs Also See for HVZ-ECO:
Table of Contents

Advertisement

Available languages

Available languages

Operation

7 Operation
7.1

General

Before using the Installation Clamp HVZ-ECO- Easy with the
carrier (excavator) release all optional transport clips at the
rotator, unconditionally. So that the clamp suspension (incl.
rotator) is fully movable.
Danger of injuring the hands!
If the arm of the support frame (excavator) is moved (with a gripped stone layer) too far to the outside, a
risk of tipping of the support frame (excavator) - due to the weight of the installation clamp and the weight
of the stone layer. Therefore note the tipping stability of the support frame (excavator).
Attention!
Before using the device check the functions.
Adjust HVZ-ECO as shown in chapter "Adjustments".
The operating of the HVZ-ECO makes use of modern drum control.
The advantage of such technics is, that according to the job specification, the different motion sequence
can be activated via a selector switch.
Never close the main clamping without an existing stone layer and already closed side clamping.
Otherwise it could happens, that the main clamping grippers are pressing against the Half rails and
thereby the gripping of the side clamping can be bent.
With the careful handling, the HVZ-ECO-Easy can also be used to gets empty pallets out of the way - to
pile up (for the lately) rational transportation. However, it must be strictly ensured, that the pallets are
not gripped with the full clamping pressure of the main clamping.
With the careful handling, the HVZ-ECO-Easy can also be used to gets empty pallets out of the way - to
pile up (for the lately) rational transportation. However, it must be strictly ensured, that the pallets are
not gripped with the full clamping pressure of the main clamping.
When gripping with the fully clamp pressure, firstly the pallets are mostly damaged and secondly, due to the
extremely high clamp pressure to individual feather-steel-lamellas could be bent, or the complete main
clamping.
In such cases, always close the main clamping just enough, so that pallets just keep!
51400034
V3
30 / 41
GB

Advertisement

Chapters

Table of Contents
loading

Table of Contents