Table of Contents
Advertisement
THIS FAN IS SUITABLE FOR DAMP LOCATIONS SUCH AS COVERED PORCHES,
COVERED PATIOS, AND COVERED DECKS... ANYWHERE THERE IS A ROOF OVERHEAD.
USE ONLY WITH LIGHT KITS MARKED SUITABLE FOR USE IN
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Tools Needed for Assembly
One Phillips head screwdriver
One wire stripper
One stepladder
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be
a 3-conductor (2-wire with ground) of following size:
Your ceiling fan is designed to be installed either in the standard manner, or in the close-to-the-ceiling manner.
Using the standard method, the hanger ball/downrod assembly will suspend the fan several inches below the ceiling
cover. Using the close-to-the-ceiling method, the ceiling cover installs directly on the fan motor housing, thus mounting
the fan 3-1/2 inches closer to the ceiling than the standard method. In no case should the fan blades be lower than
seven feet above the floor. Depending on your desired mounting method, proceed to "INSTALLING HANGER
BALL/DOWNROD ASSEMBLY" for standard mounting, or to "INSTALLING CEILING COVER ON FAN MOTOR HOUSING"
for close-to-the-ceiling mounting.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and capable
of withstanding a load of at least 50 pounds.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable for
Fan Support of 22.7kg. (50 lbs.) or less", and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
DAMP LOCATIONS.
Install, Operate and Maintain Your Ceiling Fan
IMPORTANT
Electrical Requirements
Installed Wire Length
Up to 50 ft.
50-100 ft.
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 11. If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
4
Wire Size A.W.G.
14
12
WARNING
WARNING
WARNING
U.L. Model No.: CF130
Advertisement
Table of Contents
