How To Wire Your Ceiling Fan - Emerson TILO CF130BS00 Owner's Manual

If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all
connections are tight, including ground, and that
no bare wire is visible at the wire connectors,
except for the ground wire.
1. Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the grounding conductor of supply (this
may be a bare wire or wire with green colored
insulation). Securely connect wires with wire
connectors supplied.
NOTE: When wiring the ceiling fan for close-to-the-
ceiling mounting, there will be no green grounding
lead from the hanger ball.
NOTE: If you are using an Emerson Light Fixture
with your fan, see Light Fixture Owner's Manual for
wiring.
2. Securely connect the fan motor white wire to the
supply white (neutral) wire using wire connector
supplied (Figure 16). Securely connect the fan motor
black wire to the supply black (hot) wire using wire
connector supplied (Figure 16).
3. If a downlight is not being installed cap the blue wire
using a supplied wire connector. If a downlight is
being installed a separate hot supply must be
available or an optional Emerson accessory control
must be used. Follow the installation instruction of
the accessory control, if used.
4. After connections have been made, turn leads
upward and carefully push leads into the outlet box,
with the white and green leads on one side of the
outlet box and the black and blue leads on the other
side of the outlet box.

How to Wire Your Ceiling Fan

BLUE FAN WIRE
WIRE CONNECTOR
BLACK
SUPPLY (HOT)
BLACK
FAN WIRE
WHITE SUPPLY
NEUTRAL)
WHITE FAN WIRE
Figure 16
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
Please contact 1-800-654-3545 for further assistance
11
SUPPLY
GROUND WIRE
GREEN GROUND
WIRE FROM
HANGER
BRACKET
GREEN GROUND
WIRE FROM
HANGER BALL
WARNING
emersonfans.com
U.L. Model No.: CF130