Table of Contents
Advertisement
6. Place the decorative lower cover and ceiling cover
over the downrod. Be sure both pieces are oriented
correctly (Figure 7).
7. Reinstall the hanger ball (Figure 8) on the downrod
as follows. Route the motor leads through the
downrod. Position the pin through the two holes in
the downrod and align the ball so the pin is captured
in the groove in the top of the hanger ball. Pull the
hanger ball up tight against the pin and securely
tighten the setscrew in the hanger ball. A loose
setscrew could create fan wobble.
8. The fan comes with blue, black and white leads that
are 42" long. Before installing fan, measure up
approx-imately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and
strip back insulation 1/2-inch from end of leads.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
Ceiling Fan Assembly
(continued)
Figure 7
PIN
HANGER
BALL
DOWNROD
Figure 8
Please contact 1-800-654-3545 for further assistance
7
DECORATIVE
UPPER COVER
CEILING
COVER
DECORATIVE
LOWER COVER
SETSCREW
CEILING
COVER
emersonfans.com
U.L. Model No.: CF130
Advertisement
Table of Contents
