Table of Contents
Advertisement
How to Hang Your Ceiling Fan
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
1. Position the hanger bracket on the outlet box so that
the T-slots in the hanger bracket are aligned with the
outlet box screws (Figure 12).
NOTE: The four hanger bracket screws and
lockwashers are included in the parts bag for this
fan. Must be installed for Dual-Mount and NOT used
with Downrod (standard) Mount.
WARNING
!
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
How to Hang Your Ceiling Fan For
Close-to-the-Ceiling Mounting
1. For close-to-the-ceiling mounting, the two decorative
upper covers must be removed before installation to
hanger bracket (Figure 14).
2. Carefully lift the fan assembly up to the hanger
bracket. Pass the hook on the hanger bracket
through one of the screw holes (not the slots) in the
ceiling cover (Figure 14). The hook must pass from
the inside of the ceiling cover to the outside. The
hook will hold the fan assembly while connecting the
wiring.
3. Loosely install two M5 x 10mm screws and
lockwashers (supplied) in hanger bracket at this time.
The remaining two lockwashers and screws will be
installed after the ceiling fan is hung (Figure 14).
WARNING
!
The hook must pass through the screw hole in the
ceiling cover from the inside to the outside. Any other
hanging method may cause the hook to break and the
fan to fall.
(continued)
LOOSEN TWO
SCREWS (SUPPLIED
WITH OUTLET BOX)
T-SLOT
Figure 12
HOOK
Figure 13
HOOK ON HANGER BRACKET MUST PASS THROUGH SCREW HOLE IN
CEILING COVER, INSIDE OF BRACKET TO OUTSIDE OF BRACKET
HOOK
CEILING COVER
FAN
HOUSING
Figure 14
Please contact 1-800-654-3545 for further assistance
9
OUTLET
BOX
SLIDE THE HANGER
BRACKET ONTO
THE OUTLET BOX
SCREWS, THROUGH
THE T-SLOT
HANGER
BRACKET
SECURELY
TIGHTEN
SCREWS
HANGER
BRACKET
M5 x 10mm SCREW
AND LOCKWASHER
(2 each)
DECORATIVE UPPER
COVER (2)
emersonfans.com
U.L. Model No.: CF130
Advertisement
Table of Contents
