GLP JDC Line 500 Quick Start And Safety Manual page 18

www.glp.de
Figure 8. Maximum protrusion into hole in end of fixture
To suspend the JDC Line 500 vertically from a rigging
truss or similar structure:
See Figure 9. Obtain an M10 eyebolt A that is
approved for the weight that it will support, an M10
nut B and washer C.
Thread the nut onto the eyebolt and pass the washer
over the end of the eyebolt.
Screw the eyebolt with the nut and washer into the
threaded hole in one end of the fixture by hand
without applying excessive force.
When approx. 16 mm of the eyebolt is threaded into
the fixture, the eyebolt will reach the bottom of the
hole. Unscrew the eyebolt by a quarter-turn to a half-
turn to back it up from the bottom of the hole.
See Figure 10. Holding the eyebolt to prevent it from
turning, tighten the nut B until it locks the eyebolt in
position in the end of the fixture.
Suspend the fixture by passing a cable that is
approved for the weight that it will support through
the eyebolt and around a rigging truss chord or similar
anchoring point.
Secure the fixture with a safety cable as described in
'Installing a safety cable' on page 13 if there is any risk
that the fixture will cause injury or damage if it falls.
18 JDC Line 500
Quick Start and Safety Manual Rev. A
Max.
15 mm
A
B
Figure 9. Installing an
eyebolt
B
Figure 10. Eyebolt
locked
C