Installing A Rigging Bracket - GLP JDC Line 500 Quick Start And Safety Manual

www.glp.de
To secure a JDC Line 500 fixture with a safety cable:
Loop a safety cable around a secure anchoring point such as a truss chord or fixed
structure.
See Figure 3. Loop the cable around one of the fixture's handles. Take up as much
slack as possible in the cable (by looping it more than once around the truss chord,
for example), then close the cable so that it will catch the fixture if the rigging
hardware fails.

Installing a Rigging Bracket

The JDC Line Rigging Bracket is supplied with the JDC Line 500. You can use it to
suspend the fixture from a rigging truss or fasten the fixture to a secure surface or
structure at any angle. Rigging clamps for fastening the Rigging Bracket to a truss are
available from GLP as optional accessories.
To install the Rigging Bracket on a fixture:
See Figure 4. Push the quarter-turn fasteners A on the Rigging Bracket B into the
quarter-turn mounting holes on the top of the fixture.
Turn both quarter-turn fastener handles a full 90° clockwise to lock the Rigging
Bracket to the fixture.
14
A
Figure 4. JDC Line Rigging Bracket
JDC Line 500
A
B
Quick Start and Safety Manual Rev. A