Installing Alignment Brackets; Placing On A Horizontal Surface - GLP JDC Line 500 Quick Start And Safety Manual

Hide thumbs Also See for JDC Line 500:

Table of Contents

German Light Products®

Installing Alignment Brackets

Warning! You can use the JDC Line's Alignment Brackets to align any

number of fixtures, but you may only use them to support weight in the case

of maximum four (4) JDC Line 500 fixtures fastened together and hanging

vertically.

The JDC Line 500 system includes Alignment Brackets that can be locked onto the top

and bottom surfaces of two fixtures to fasten them end-to-end.

To fasten up to four JDC Line 500 fixtures end-to-end:

See Figure 5. Place the fixtures on a flat surface with enough space for the fixtures

to lie end-to-end. Slide the ends of the fixtures together so that the alignment

profiles A engage.

Fasten an Alignment Bracket B onto the tops of each pair of fixtures using the

bracket's quarter -turn fasteners C. Turn the quarter-turn fasteners a full 90° to lock.

Keeping the fixtures supported and in a straight line, turn them over as one unit and

fasten a second Alignment Bracket onto the opposite side of each pair of fixtures

as you did with the first bracket. Check that the fixtures are now fastened securely

to each other.

You can place a JDC Line 500 fixture on a horizontal surface so that the fixture is lying

horizontally.

You can stack multiple fixtures on top of each other in a column but you must stabilize

the column with hardware fastened to the M10 threaded holes on the tops and

bottoms of fixtures and to secure anchoring points so that it is impossible for the column

of fixtures to fall.

JDC Line 500 Quick Start and Safety Manual Rev. A

Figure 5. JDC Alignment Bracket

Table of Contents