Control Keys - VAN DER ENDE Vacon 100 Flow Manual

2.3 Control keys

Stop
Start
Back/Reset
This key returns you to the menu. You can also use this key to end an entry without it being
stored.
If a problem has been resolved, the frequency converter can be reset by holding this key for
a few seconds.
Funct
The funct key can be used anywhere in the programme to switch from Local (keypad) to
Remote (I/O or fieldbus) operation. The operation page can also be selected.
OK
This key allows you to enter a folder or parameter. It also confirms a change to a parameter
(stored in EPROM).
Menu key up
Use this key to scroll up through main menus and sub-menus, or change the value in a
parameter.
Menu key down
Use this key to scroll down through main menus and sub-menus, or change the value in a
parameter.
Menu key left
This key can be used when changing each digit of a parameter.
Menu key right
This key can be used when changing each digit of a parameter.
If the parameter is selected, you can change the parameter immediately by holding down
this key.
Start
This key starts the motor when in local control mode (see Loc/Rem).
Stop
This key stops the motor when in local control mode (see Loc/Rem). In remote control
mode, this key also stops the motor when "keypad stop key" is enabled (parameter M3.2.2).
Vacon 100 Flow 7
page