Table of Contents
Advertisement
3.2 Viewing and modifying a parameter
For example, we want to view and change the maximum frequency (P 3.3.1.2).
Go to the Main Menu, and scroll up or down with the arrow keys to the Parameters folder,
then press OK. Scroll through this menu to References, then press OK.
Scroll to Max. frequency, and press OK.
You have three options; Edit/Help/Add to favourites.
Scroll to Edit, then press OK (the value now starts to flash).
The target frequency can now be entered with the arrow keys.
is being made can also be selected with the left and right arrow keys. This figure is
underlined.
After changing the value, you can save it by pressing OK.
3.3 Monitoring Menu
In the monitoring menu, monitor values can be displayed simultaneously via multimonitor 9,
6 or 4. A graph with 2 monitor values can be viewed via the trend curve.
3.3.1 Change multimonitor menu
If you hover over one of the Multimonitor fields and then press OK, you can select the
required monitor parameter by scrolling up or down, and confirm with the OK key.
The number of display fields can be changed with parameter (P3.11.4); the options are 3x3,
3x2 and 2x2
3.3.2 Trend Curve
Selecting a monitor value below the graph shows a graph of this value. In
the trend menus, it is possible to adjust the interval time and the minimum
and maximum of the value to be displayed, or to switch to auto-scaling.
OK
The place where the change
OK
Vacon 100 Flow
10
page
Advertisement
Table of Contents
