Table of Contents
Advertisement
3.9 Favourites folder
The Vacon 100 frequency converter allows compilation of a folder containing frequently-
used parameters. It means you can access all the parameters from a single folder, and
modify them if necessary. Please note! The favourites folder is deleted when changing the
firmware, although it can be saved in the control panel.
3.9.1 Saving parameters in the favourites folder
OK
OK
OK
3.9.2 Removing parameters from the favourites folder
OK
OK
OK
OK
3.10 Cooling fan control
Parameter P5.6.1.1 (Fan optimisation) turns the unit's cooling fan on or off. (From MR6
speed control)
If this parameter is switched on, the cooling fan will be switched to the unit temperature.
When switching the power supply on, the cooling fan will always run and then turn off after
around 5 minutes, if:
- the regulator is in ready or sleep state.
- the unit temperature is not too high.
If the regulator is in run mode, the fan will run continuously regardless of the temperature
of the unit.
Vacon 100 Flow
17
page
Advertisement
Table of Contents
