Fluke i1000s Manual Supplement

Hide thumbs Also See for i1000s:

Manual Title:

Part Number:

Print Date:

Revision/Date:

This supplement contains information necessary to ensure the accuracy of

the above manual. Enter the corrections in the manual if either one of the

following conditions exist:

The revision letter stamped on the indicated PCA is equal to or higher

than that given with each change.

No revision letter is indicated at the beginning of the change.

Manual Supplement

i1000s Calibration

1574933

May 2001

Supplement Issue:

Issue Date:

Page Count:

7/01

Table of Contents

Need help?

Do you have a question about the i1000s and is the answer not in the manual?

Page 1 The revision letter stamped on the indicated PCA is equal to or higher than that given with each change. No revision letter is indicated at the beginning of the change. © 2001 Fluke Corporation. All rights reserved. Printed in U.S.A.
Page 2 Calibration Manual Supplement Change #1 On page 8, Table 4, under Recommended Model, Replace: Digital Multimeter Hp 3458A or equivalent With: Digital Multimeter Agilant 3458A or equivalent Delete the following from Table 4, AC/DC Shunt IET Labs-DCCS-200 0.1e - 0.1% non-inductive...
Page 3 Output Test 1. Connect the equipment as shown in Figure 5. 2. Set the calibrator output and coil for each step of Table 5. 3. Verify that the voltmeter reading is within the “i1000S mV Output” limits of Table 5. 7/01...

1574933