KROHNE UFM 3030 K EEx Series Addition To The Installation And Operating Instructions page 3

Disclaimer
•
This document contains important information on the instrument. KROHNE attempts to be as
accurate and up-to-date as possible but assumes no responsibility for errors or omissions. Nor
does KROHNE make any commitment to update the information contained herein. This manual
and all other documents are subject to change without prior notice.
•
KROHNE will not be liable for any damage of any kind by using its instrument, including, but not
limited to direct, indirect, incidental, punitive and consequential damages.
•
This disclaimer does not apply in case KROHNE has acted on purpose or with gross negligence.
In the event any applicable law does not allow such limitations on implied warranties or the
exclusion of limitation of certain damages, you may, if such law applies to you, not be subject to
some or all of the above disclaimer, exclusions or limitations.
•
Any instrument purchased from KROHNE is warranted in accordance with the relevant product
documentation and our Terms and Conditions of Sale.
•
KROHNE reserves the right to alter the content of its documents, including this disclaimer in any
way, at any time, for any reason, without prior notification, and will not be liable in any way for
possible consequences of such changes.
Product liability and warranty
•
Responsibility for suitability and intended use of this ultrasonic flow meter rests solely with the
user. Improper installation and operation of the flow meter (system) may lead to loss of warranty.
•
In addition, the Terms and Conditions of Sale are applicable and are the basis for the purchase
contract.
•
If flow meters need to be returned to KROHNE, please note the information given on the last
pages of the installation and operating instructions. KROHNE regrets that they cannot repair or
check flow meter(s) unless accompanied by the completed form (see last pages of the
installation and operating instructions).
Items included with order
•
UFM 3030 ultrasonic flow meter, comprising of a flow sensor, UFS 3000 and a flow converter,
UFC 030 either built together as a compact system or supplied as two separate pieces, in the
size as indicated on the packaging box
•
Signal cable (only in case of a separate system)
•
Special tool for opening the converter housing
Documentation supplied
•
Condensed installation and operating manual
•
For Ex-units: installation and operating instructions for use in hazardous areas
•
Instruction card: overview of the configuration menu and display markers
•
Service Handbook
•
Approval documents, unless reproduced in the installation and operating instructions
•
Report of factory settings of the flow converter
•
Certificate of system calibration data
This instrument is developed and manufactured by:
KROHNE Altometer
Kerkeplaat 12
3313 LC Dordrecht
The Netherlands
For information, maintenance or service please contact your nearest local KROHNE representative.
UFM 3030 3