7th Sense Delta Media Server User Manual page 7

Installation
Lifting
Delta Media Server weight depends on model and specification, the weight is stated on the server's product
label. Larger servers may require a two-person lift, especially when manoeuvring them into a rack. Observe
your internal manual handling recommendations to avoid injury.
Rack Mounting
Delta Media Servers (2U and 3U models) are supplied with rack mount slide rails and fixings. Ensure that each
server is properly secured to the rack cabinet.
Delta 1U servers should be installed in a rack using a minimum of an M6 rack mount bolt in each of the top
and bottom mounting holes on each side of the server's front panel.
To fit the rails supplied, follow the instructions included with the rails.
For Pico servers mounted in rack trays follow the
Rack Stability Precautions
Ensure the rack is stable (e.g. bolted to the floor) before sliding out the server.
·
Do not place objects on equipment projecting from a rack (e.g. do not use as a shelf).
·
Only slide out one piece of equipment from the rack at a time.
·
Connecting External Equipment
To ensure best performance from the server and compliance with relevant EMC regulations, this equipment
should only be used with high-quality shielded data and signal cables.
Only equipment and accessories approved to IEC 60950-1 and SELV circuits may be connected to the server.
All equipment and accessories shall comply to the relevant standard for the server's port to which it is
connected.
Cleaning
External casing and the front panel should be carefully wiped with a soft cloth and antistatic solution.
Hardware Operation
online user guide.
7
© 2020 7thSense Design