Basic Operation; Basic Procedure For Effect Editing; Effect Placement - Boss GT-1000CORE Parameter Manual

Basic Operation

Basic Procedure for Effect Editing

The edit screens show the block configuration (effect chain) of all
effects provided by the GT-1000CORE, as well as the output and
send/return. You can edit from this effect chain display by selecting
the block that you want to edit.
1
Press the [EFFECT] button.
The edit screen (effect chain) appears.
2
Turn knob [6] to select the block that you want to
edit.
The selected block is enclosed by a thick frame.
* By pressing knob [SELECT] you can turn the selected effect on/off.
Effects that are off are shown in gray. When the effect is turned on,
it is shown in white.
Off On
3
Use knobs [1]–[5] to adjust the parameters that are
shown below the screen.
Use the PAGE [ K ] [ J ] buttons to switch between the parameters
that you want to edit. The current page is indicated in the lower
center of the screen.
* To change a value in larger steps, turn a knob while pressing it.
* The number of parameters and pages differs depending on the
effect.
Editing while viewing all parameters
From the edit screen, you can long-press knob [SELECT] to see a list
of all parameters of the selected block. You can edit the parameters
from this list.
1
Turn the [SELECT] knob to select the item that you
want to set.
Turning the knob will move the selected item vertically.
2
Turn knobs [1]–[6] to edit the value of the
parameters shown in the screen.
Use the PAGE [K] [J] buttons to switch between lists of parameters.

Effect Placement

By moving blocks such as effects, output, and send/return, you can
freely change the order in which the effects are placed, or arrange
them in parallel.
Changing the placement of effects etc.
1
Press the [EFFECT] button.
The effect chain is shown.
2
Use knob [SELECT] to select the block that you
want to move.
3
While pressing knob [SELECT], turn it left or right.
The selected block moves left or right.
3