Cho Bass (Chorus Bass); C-Vibe (Classic Vibe); Comp (Compressor) - Boss GT-1000CORE Parameter Manual

Effect

CHO BASS (CHORUS BASS)

This is a chorus effect for bass.
Parameter Value
ON/OFF OFF, ON
Selection for the chorus mode.
MONO
STEREO 1
TYPE
STEREO2
0–100,
RATE
BPM ΠР`
DEPTH
0–100
E.LEVEL 0–100
FLAT,
LO CUT *1
20.0Hz–20.0kHz
20.0Hz–20.0kHz,
HI CUT *1
FLAT
BPM 40–250
16
Explanation
Turns this effect on/off.
This chorus effect outputs the same sound
from both L channel and R channel.
This stereo chorus uses spatial synthesis,
with the direct sound output in the L
channel and the effect sound output in the
R channel.
This is a stereo chorus effect that adds
different chorus sounds to L channel and
R channel.
Adjusts the rate of the chorus effect.
* When set to BPM, the value of each
parameter will be set according to the
value of the "MASTER BPM" specified
for each patch. This makes it easier to
achieve effect sound settings that match
the tempo of the song.
* If, due to the tempo, the time is longer
than the range of allowable settings, it is
then synchronized to a period either 1/2
or 1/4 of that time.
Adjusts the depth of the chorus effect.
* To use it for doubling effect, set the
value to 0.
Adjusts the volume of the effect sound.
This sets the frequency at which the low
cut filter begins to take effect. When FLAT
is selected, the low cut filter will have no
effect.
This sets the frequency at which the high
cut filter begins to take effect. When FLAT
is selected, the high cut filter will have no
effect.
Adjusts the BPM value for each patch.
* BPM (beats per minute) indicates the
number of quarter note beats that occur
each minute
* When you have an external MIDI
device connected, the MASTER BPM
synchronizes to the external MIDI
devices tempo, making it impossible to
set the MASTER BPM. To enable setting
of the MASTER BPM, set "SYNC CLOCK"
(p. 47) to "INTERNAL. "

C-VIBE (CLASSIC VIBE)

Although this resembles a phaser effect, it also provides a unique
undulation that you can't get with a regular phaser.
Parameter Value
CHORUS
MODE
VIBRATO
0–100,
RATE BPM ΠР`
0–100
DEPTH
E.LEVEL
0–100
BPM
40–250

COMP (COMPRESSOR)

This is an effect that produces a long sustain by evening out the
volume level of the input signal.
Parameter Value
ON/OFF OFF, ON
BOSS COMP
X-COMP
D-COMP
TYPE
ORANGE
STEREO COMP
X-BASS COMP
THRESHOLD
0–100
*1
SUSTAIN *2 0–100
ATTACK 0–100
LEVEL 0–100
TONE -50–+50
RATIO 1:1–INF:1
DIR MIX 0–100
*1 Setting available when TYPE is set to X-BASS COM.
*2 Not shown if TYPE is set to X-BASS COMP.
Explanation
Direct sound and effect sound are mixed and
output.
Only effect sound is output.
Adjusts the rate of the effect.
* When set to BPM, the value of each
parameter will be set according to the
value of the "MASTER BPM" specified for
each patch. This makes it easier to achieve
effect sound settings that match the
tempo of the song.
* If, due to the tempo, the time is longer than
the range of allowable settings, it is then
synchronized to a period either 1/2 or 1/4
of that time.
Adjusts the depth of the effect.
Adjusts the tone.
Adjusts the BPM value for each patch.
* BPM (beats per minute) indicates the
number of quarter note beats that occur
each minute
* When you have an external MIDI device
connected, the MASTER BPM synchronizes
to the external MIDI devices tempo,
making it impossible to set the MASTER
BPM. To enable setting of the MASTER BPM,
set "SYNC CLOCK" (p. 47) to "INTERNAL. "
Explanation
Turns this effect on/off.
This models a BOSS CS-3.
This uses MDP to provide a consistently natural
playing feel and sound that responds to the
pitch range and dynamics of your phrases.
This models a MXR DynaComp.
This is modeled on the sound of the Dan
Armstrong ORANGE SQUEEZER.
This selects a stereo compressor.
This is a compressor for bass that uses MDP.
Adjust this as appropriate for the input
signal. When the input signal level exceeds
this threshold level, compression will be
applied.
Adjusts the range (time) over which low-
level signals are boosted. Larger values will
result in longer sustain.
Adjusts the strength of the attack when
picking.
Adjusts the volume.
Adjusts the tone.
Selects the compression ratio.
Adjusts the volume of the direct sound.