Sealing The Bag (Without Vacuum) - Silvercrest SVEB 160 A1 Operating Instructions Manual

3. Place the bag in the device. For this pur-
pose, the end of the film bag must be
positioned just before the rear reference
ridges 12 and the side reference ridg-
es 13.
4. Ensure that there are no creases in the
film bag - especially above the welding
wire 15.
5. Close the lid 17 and press it down
slightly.
6. Press the button
vice to standby. The LED is lit.
7. Press the button
film bag is first vacuum-packed and
then sealed.
The LED goes out when the process is
complete.
NOTE: if the LED 5 does not go out and the
noise of the vacuum pump does not stop, de-
spite the fact that no further air is being
sucked out of the film bag, cancel the pro-
cess. Check that the film bag is in the correct
position in the device, and check for leaks.
8. Open the lid 17 and remove the bag.
9. Check the welding seam. It should be a
smooth creaseless seam.
1 to switch the de-
5. The LED is lit. The
9.5 Sealing the bag
(without vacuum)
1. Proceed in the same way as for vacu-
um-packing and sealing (see "Vacuum-
packing and sealing the bag" on
page 30) until step 6.
2. Place the vacuum bagging tube in the
vacuum sealer on the front edge of the
lower sealing ring 14.
3. Press the button
The film bag is being sealed. The seal-
ing process is automatically terminated
and the LED goes out.
4. Open the lid 17 and remove the bag.
5. Check the welding seam. It should be a
smooth creaseless seam.
6. The LED is lit.
31
GB