Table of Contents
Advertisement
CITY SERIES 60
6. Place Log 1 on top of the log guide. The pin under Log 1 and the log
guide will act as a guide for Log 1's proper positioning.
7. Install Log 2 to the left of Log 1. Make sure they are connected.
2
8. Install Log 3 to the right of Log 1. Rest the left side on the log guide.
Connect Log 1 and Log 3 to make the split between less visible.
9. Insert the pin of Log 4 into the hole. The left end of Log 4 should sit
1-1/4" from the edge of the panel, as shown below.
4
920-163
10. Insert the pin of Log 5 into the hole on the left side of the pilot. Position
1
11. Insert the pin of Log 6 into the hole on the right side of the pilot. Posi-
12. Insert the pin of Log 7 into the hole on the right-most side. Position
3
13. Install one box (3.5 lbs) of 3/4" black coal (optional) around the logs
1 1/4"
2
the left end of Log 5 2-1/8" from the edge of the panel.
tion the right end of Log 6 2" from the edge of the panel.
the left end of the log 1-1/8" from edge of panel, as shown below.
1 1/8"
installed on the panels, as shown below.
Do not completely cover secondary air inlets-leave them 50% open.
Correct Black Coal placement
installation
5
2 1/8"
6
2"
7
City Series CB60E | 85
22.10.19
Advertisement
Table of Contents
