Technical Data - Melitta Cafina XT4 Operating Instructions Manual

Do not hold any body parts under the outlets
•
when hot liquids or steam are being dispensed.
This occurs in the following situations:
After switching on
͵
When beverages are being dispensed
͵
During automatic cleaning
͵
During rinsing processes (e.g., when switch-
͵
ing off)
Do not touch any hot parts.
•
When products are being dispensed, there
•
is a risk of scalding from the actual products.
Always take care when handling hot beverages.
Take note of any visible damage or malfunc-
•
tions. Obvious malfunctions include water
leaks, odors and heat formation, unusual
noises, as well as error messages on the display.
In the event of any unusual situation:
Disconnect the mains plug
͵
Switch off the water supply
͵
Contact customer service
͵
Have the machine checked and repaired by
͵
customer service
Clean the machine at least once per day, espe-
•
cially the parts in contact with milk. Impurities
could cause health problems.
Comply with all intervals for cleaning, inspec-
•
tion, and maintenance, as specified in the
instructions. Otherwise, the safety, functional
reliability, and durability may be impaired.
35878 • 20201001

Technical data

3

Technical data

Machine specifications
Dimensions (W x D x H)
Weight
Coffee supply
Instant supply
Coffee grounds drawer
capacity
Operating data
Hourly output
Permissible ambient
temperature
Permissible air humidity
Noise level
Electrical connection
Power supply
Power consumption
Fuse protection
provided by customer
Connection
Water connection
Fresh water connection
Fresh water pressure
Fresh water carbonate
hardness
Waste water connection
300 x 580 x 715 mm
approx. 60 kg
2 x 3 l / 2 x approx. 1000 g
1 x 1.7 l / 1 x approx.
1300 g or
2 x 1 l / 2 x 450-800 g
For approx. 30 portions
approx. 25 l hot water or
approx. 100 cups of Café
Crème
+ 5-30 °C
< 80 % non-condensing
< 70 dB(A)
200-240 V, 50-60 Hz
2175-3040 W
16 A (required)
1.8 m mains cable with
shock-proof mains plug
G ¾" outer thread
At least 0.25 MPa
(2.5 bar) at approx. 2 l/
min, a pressure reducer
is required for static
pressures higher than
0.6 MPa (6 bar)
1-3 °dKH: no action
required, 4 °dKH and
above: decarbonization
system required (e.g.,
BRITA-Purity), less
than 1 °dKH: consult
manufacturer
At least DN 25 - NW 1"
7
2
3