Scott TIME TRIAL MACHINE Owner's Manual page 108

After cleaning and drying (a) check the chain for wear (b) and relubricate (c)
(see the chapter "Bicycle chain" and the manuals of the component manufac-
turers).
Apply a coat of standard hard wax (d) on painted, metal and carbon surfaces
(except from brake surfaces and brake discs). Polish the waxed surfaces after
drying to give them a nice shine.
WARNING
Keep cleaning agents and chain oil clear of the brake pads, brake discs and
rim sides (braking surfaces). Otherwise the brake could fail. Never grease
or lubricate the clamping areas of a frame made of carbon, e.g. handlebars,
stem, seat post and seat tube. Once greased, carbon components may never
again ensure reliable clamping!
While cleaning, watch out for cracks, scratches, dents as well as deformed
or discoloured material. Have defective components replaced immediately
and touch up paint defects. If you are in doubt or if you have any questions,
contact your SCOTT dealer.
NOTICE
Do not clean your SCOTT bike with a high-pressure cleaner or a water jet
and if you do, be sure to keep it at a distance. Do not aim at the bearings.
Only use petroleum-based solvents for cleaning tough oil or grease stains
from paint and carbon surfaces. Never use degreasing agents containing
acetone, methyl chloride or the like, or solvent-containing, non-neutral or
chemical cleaning agents that could attack the surface!
The use of third Party Bike Shields / Protective Film is prohibited.
a
| 108 ENGLISH
b c
OWNER'S MANUAL 2021 | ROAD BIKE