Mitsubishi Electric ME96 Super-S Series Manual page 17

(2) For measurement with VT
eVT/Direct voltage
<Secondary voltage settings>
DISPLAY SET
<Set primary voltage>
The setting ranges from 60 V to 750,000 V (setting unit: V)
Factory default settings
rCT current rSet CT.
Set the primary and secondary currents of the CT to be combined.
<Set secondary current>
<Set primary current>
DISPLAY SET
The setting ranges from 1.0 A to 30,000.0 A (setting unit: A)
Factory default setting: 5.0 A
tSet frequency.
tFrequency
Notes1. Analog output scale will also change.
DISPLAY SET
yRolling demand time ySet the rolling demand interval time limit
limit (1) Interval time limit
(2) Sub-interval time limit
DISPLAY SET
uCurrent demand time
uSet the current demand time limit.
limit
SET
Set-up menu
Select another set-up menu or finish set-up.
‡To continue to set-up
Select the menu No.
using the
Set-up menu 2: MODBUS RTU Communication settings
(When ME-0040C-SS96, ME-0000MT-SS96 and ME-0040MT2-SS96 are not installed)
Set-up menu
Adjust the set-up menu No. to "2".
DISPLAY SET
qMODBUS RTU
qSet MODBUS RTU communication address
communication address
Possible address settings: 1-255
DISPLAY SET
wSet the MODBUS RTU communication baud rate.
wMODBUS RTU
Baud rate
DISPLAY SET
(a) 3-phase 4-wire setting (phase voltage)
63.5 V 100 V 110 V
(b) 3-phase 3-wire (2CT, 3CT) or 1-phase 2-wire setting (line voltage)
100 V 110 V 220 V
3-phase 4-wire: 200 V (phase voltage)
3-phase 3-wire; 1-phase 2-wire: 10,000 V (line voltage)
1 A 5 A
50 Hz 60 Hz
(Only ME96SSHB-MB and
Setting range Setting interval
1 - 15 - 60 (min) 1 min
Setting range Setting interval
1 - 60 (min) 1 min
0 s 40 s 3 min 7 min
10 s 50 s 4 min 8 min
20 s 1 min 5 min 9 min
30 s 2 min 6 min 10 min
or button.
2400 bps
4800 bps
9600 bps
19.2 kbps
38.4 kbps
115 V 120 V
t
ME96SSRB-MB).
u
15 min
20 min
25 min
30 min
‡To finish set-up
Press the or button
to display the End screen,
then press the button
SET
to save the settings.
q
e(2)
r
y
w
16