Table of Contents
Advertisement
Description and use of hood
(Figure 13)
1. Control panel
2. Front panel
3. Grease filters
4. Carbon filters (Filter Version only)
5. Lighting
CONTROL PANEL (Figure 14)
The hood has a "TOUCH" device for control of lights and speed.
For correct use, carefully read the instructions below.
• Button T1:
Delays hood switch-off, timing the set speed for a few minutes.
With this function, the hood switches off at the end of the time.
Operation times are as follows:
• extraction speed (power) 1: 20 minutes.
• extraction speed (power) 2: 15 minutes.
• extraction speed (power) 3: 10 minutes.
• extraction speed (power) 4: 5 minutes.
Press button T2 or T3 and the hood exits timed mode and the extraction speed (power) decreases or
increases depending on the button pressed. During the timing stage, the LED corresponding to the speed
blinks.
IMPORTANT: When operating the timer, the hood might switch to a lower intake speed (power)
before turning off, as on some speeds there is already a timing on the speed reduction itself.
• Button T2:
Decreases the active extraction speed (power) (4→3→2→1→OFF). The speed is displayed by lighting
up of the LED corresponding to the speed. Button T2 has no effect on extraction panel opening/closing.
• Button T3:
Increases the active extraction speed (power) (1→2→3→4). The speed is displayed by lighting up of
the LED corresponding to the speed.
IMPORTANT: (only for models fitted with a motor or a remote GME 22):
Suction speed 4 (power) is timed for 6 minutes, after which the hood will automatically switch to
suction speed 3 (power).
IMPORTANT: If the panel is closed (hood off), button T3 firstly operates extraction panel opening and
then sets the hood to extraction speed (power) 1.
• Button T4:
Switches on the light.
IMPORTANT: If the extraction panel is closed (hood off), button T4 firstly operates extraction panel
opening and then switches on the light.
14
Fig. 13
Fig. 14
Advertisement
Table of Contents
