Table of Contents
Advertisement
1-1. Installation Environment
1. Do not install the BDX-E1000 in the following
locations.
• Areas where the unit will be exposed to direct sun
light or any other strong lights.
• Dusty areas or areas where it is subject to vibration.
• Areas with strong electric or magnetic fields.
• Areas near heat sources.
• Areas where is subjected to electricity noise.
• Areas where is subjected to static electricity noise.
2. To prevent the temperature rise inside the BDX-
E1000, pay careful attention to circulation of air in the
place where the BDX-E1000 is installed.
The rear side of the BDX-E1000 should be at least
20 cm away from walls for ventilation and
maintenance.
c
Do not block the ventilation holes.
If the ventilation holes are blocked, the temperature inside
the BDX-E1000 getting rise. This may cause a fire.
1-2. Power Supply
1-2-1. Power Specifications
Power requirements : 100 to 240 V AC
50/60 Hz
Current consumption : maximum 2.0 A (at 100 V)
maximum 1.0 A (at 240 V)
A switching regulator is used for the power supply of the
BDX-E1000. The voltage within the range of 100 V to
240 V can be used without changing the supply voltage.
n
As the inrush current at turn-on is maximum 20 A (at
100 V)/maximum 40 A (at 240 V), the capacity of the AC
power must be adequate with the inrush current of
maximum 20 A (at 100 V)/maximum 40 A (at 240 V).
If the capacity of the AC power is not the adequately large,
the breaker of the AC power at the supply side will operate
or the BDX-E1000 will abnormal operate.
BDX-E1000
Section 1
Installation
1-2-2. Power Cord
w
To avoid a fire or an electric shock, be sure to use the
designated power cord.
And do not damage to the power cord.
Power cord for the customer in the U.S.A. and Canada.
1 Power cord set
2 Plug holder (Black)
Power cord for the customer in the United Kingdom.
1 DK-2401 (UK) (approx. 2.4 m)
2 Plug holder (Black)
Plug holder is included in DK-2401 (UK).
Power cord for the customer in Europe except the
United Kingdom.
1 DK-2401 (AE) (approx. 2.4 m)
2 Plug holder (Brown)
Plug holder is included in DK-2401 (AE).
n
For the customer outside of the area as shown above or in a
part of Europe, the above-mentioned power cords con not
be used.
Use the power cord that is applicable to the places in the
world.
! 1-557-377-11
2-990-242-01
1
2
AC inlet
2-990-242-01
1
2
3-613-640-01
1
2
AC inlet
AC inlet
1-1 (E)
Advertisement
Table of Contents
