Table of Contents
Advertisement
2-3. BDKP-E1003 Installation
2-3. BDKP-E1003 Installation
Install the BDKP-E1003 (DEC-106 board) on the ENC-40
board which has board suffix -14 and higher.
n
To install the BDKP-E1003 (DEC-106 board) , it needs to
meet the following conditions.
. SY-240 board : Board suffix -13 and higher
. VPR-33 board : Board suffix -13 and higher
Installation procedures
1. Remove the ENC-40 board from the BDX-E1000.
(Refer to the Section 2-1.)
2. Fix the two PCB holders supplied with the BDKP-
E1003 to the ENC-40 board.
2-4 (E)
3. Match the connectors CN1 and CN2 on the DEC-106
4. Connect the connectors on the DEC-106 board to the
PCB holders
5. Insert the ENC-40 board into the Slot No.1. (Refer to
6. Install the board retainer with the four screws.
7. Close the front panel.
ENC-40 board
8. Tighten the locking screw.
Confirmation after installation
There is no necessity to confirm/adjust after DEC-106
board installing.
board with the connectors CN1 and CN2 on the ENC-
40 board.
connectors on the ENC-40 board while inserting the
PCB holders through the holes on the DEC-106 board.
n
Make sure that the connectors are connected tightly.
DEC-106 board
CN1
PCB holder
CN1
PCB holder
the Section 2-1.)
CN2
CN2
ENC-40 board
BDX-E1000
Advertisement
Table of Contents
