Remote Controller Installation - Takagi GS-20W-AU5 Installation Manual And Owners Manual

REMOTE CONTROLLER INSTALLATION

1. Crimp the fork terminals provided to the wires.
• Minimum 18AWG wire (No polarity)
• Maximum 100m long
2. Attach the crimped fork terminals on the end of the wiring to the terminals on the back of the
controller.
3. Install the wiring downward through the cable trench and
out the bottom of the connector base.
4. Fix the remote controller in position using the two screws provided or alternatively use another
fixing solution suitable for the material to be fixed to.
DO NOT locate the remote controllers where they may come into contact with water.
•
DO NOT position the remote controllers in the vicinity of chemicals.
•
DO NOT position the remote controllers over a cooker, grill or toaster.
•
DO NOT position the remote controllers where materials may spill onto them.
•
PLEASE NOTE IF THE CONTROLLERS ARE TO BE FITTED TO A METAL SURFACE, AN IN-
•
SULATION PLATE SHOULD BE PROVIDED BEHIND THE MOUNTING POSITION.
Use the fork terminals
WARNING
15
25 mm
45 mm
REMOTE CONTROL WIRING
Connector base