Table of Contents
Advertisement
11. REMOTE CONTROLLER (OPTIONAL ITEM)
The water heater can be installed with up to three remote controllers. The remote controller
has two functions which can adjust the output temperature of hot water and indicate the error
code on the remote controller. The remote controllers are optional items.
• The output water temperature can be adjusted only by a remote controller which has the
setting temperature priority with the PRIORITY lamp of the remote controller on. If you want
to change the setting temperature with another remote controller, press the PRIORITY button
of the remote controller you want to use, only when there is no water flow through the water
heater. (Default set temperature is 40 °C.)
• All water heater models have a self diagnostic function for safety and convenience. If there is a
problem with the installation or the unit, it will display an error code on the remote control-
ler if it is installed and the LED of the computer board will flash.
MAIN REMOTE CONTROLLER (MC-110-AU)
MC-110-AU
Location-
•
en) due to NO water resistant. Be careful of installation location.
The controller can adjust the output water temperature within the range from 37 °C to 50 °C
•
when it is connected to GS-20W/26W-AU5. (See the chart below.)
The controller can adjust the output water temperature with in the range from 37 °C to 60 °C
•
when it is connected to GS-20W/26W-AU6. (See the chart below.) When "BURNER ON" lamp
is on, the set temperature can not be adjusted to 55 and 60 °C. If you want to set it to 55
and 60 °C, you should close the hot water tap.
SHOWER CONTROLLER (FC-110-AU)/ENSUITE CONTROLLER (SC-110-AU)
FC-110-AU
and
•
tioned where they can be splashed directly and there should be caulking between the surface
of the wall and the controller.
FC-110-AU
is installed such as the main bathroom, and
•
ensuite bath room.
The controllers can adjust the output water temperature within the range from 37 °C to 50 °C.
•
(See the chart below.)
When BURNER ON lamp is on, the set temperature can not be adjusted to 42 °C or over. If you
•
want to adjust the set temperature to 42 °C or over , you should close the hot water tap.
MC-110-AU
Main
Water temperature setting options
MC-110-AU
37
FC-110-AU
37
SC-110-AU
*Factory setting (Default): 40 °C
**Setting of the output temperature of 55 °C and 60 °C are only available when it is connected to GS-20W/26W-AU6.
must be installed in dry, shaded and clean locations (such as kitch-
SC-110-AU
controllers are water resistant, however should not be posi-
Shower
38
39
40*
38
39
40*
SC-110-AU
FC-110-AU
41
42
43
44
41
42
43
44
14
is installed such as the
SC-110-AU
Ensuite
(Unit:°C)
45
46
47
50
45
46
47
50
55** 60**
Hide quick links:
Advertisement
Table of Contents
