Cypress PowerPSoC CY3267 User Manual page 9

Figure 2-2. CY3267 PowerPSoC - InstallShield Wizard
5. After the installation is complete, the kit contents are available at the following location:
<Install_Directory>\CY3267 PowerPSoC\<version>
Note For Windows 7 users, the installed files and the folder are read-only. To change the prop-
erty, right-click the folder and select Properties > Attributes; disable the Read-only radio but-
ton. Click Apply and OK to close the window.
6. When installing the CY3267 PowerPSoC Lighting Evaluation Kit, the installer checks if the
required software is installed in the system. If the required applications are not installed, then the
installer prompts you to download and install them. The following software is required:
a. PSoC Designer 5.4 or later: Download the latest version from www.cypress.com/go/psocde-
signer.
b. PSoC Programmer 3.19.1 or later: Download the latest version from www.cypress.com/go/
Programmer.
c. Code examples: After the kit installation is complete, the code examples are available in the
kit firmware folder.
After installing the software, verify your installation and setup by opening PSoC Programmer with the
MiniProg attached to the J12 programming header on the main board and the USB cable connected
between the MiniProg and a USB port on your PC.
CY3267 PowerPSoC Lighting Evaluation Kit User Guide, Document No. 001-49266 Rev. *I
Getting Started
9