Block Diagram; Power Connections - Texas Instruments WR1843 Series User Manual

www.ti.com
2.1

Block Diagram

Figure 3 shows the block diagram.
2.2

Power Connections

The BoosterPack is powered by the 5-V power jack (2.5-A current limit), shown in
the power is provided, the NRST and 5-V LEDs should glow, indicating that the board is powered on.
NOTE: After the 5-V power supply is provided to the EVM, it is recommended to press the NRST
switch (SW2) one time to ensure a reliable boot-up state.
SPRUIM4B – December 2018 – Revised May 2020
Submit Documentation Feedback
Figure 3. Block Diagram
Figure 4. Power Connector
xWR1843 Evaluation Module (xWR1843BOOST) Single-Chip mmWave
Copyright © 2018–2020, Texas Instruments Incorporated
Hardware
Figure 4. As soon as
5
Sensing Solution