IBM Power System Series Manual page 83

Managing pcie adapters for the machine types 9008, 9009, 9040, 9080, 9223, and the emx0 pcie3 expansion drawer
Hide thumbs Also See for Power System Series:
Table of Contents

Advertisement

Slot requirement
For details about slot priorities, maximums, and placement rules, see PCIe adapter placement rules
and slot priorities (http://www.ibm.com/support/knowledgecenter/POWER9/p9eab/
p9eab_mtm_pciplacement.htm) and select the system you are working on.
Voltage
3.3 V
Form factor
Full-height, full-length adapter with standard-size bracket
FC compatibility
2, 4, and 8 gigabit FC devices
Cables
Cables are the responsibility of the customer. Use multimode fibre optic cables with short-wave
lasers that adhere to the following specifications:
• OM3: Multimode 50/125 micron fibre, 2000 MHz x km bandwidth
• OM2: Multimode 50/125 micron fibre, 500 MHz x km bandwidth
• OM1: Multimode 62.5/125 micron fibre, 200 MHz x km bandwidth
Because core sizes are different, only OM1 cables can be connected to other OM1 cables. For best
results, do not connect OM2 cables to OM3 cables. However, if an OM2 cable is connected to an OM3
cable, the characteristics of the OM2 cable applies to the entire length of the cables.
The following table shows the supported distances for the three different cable types at the three
different link speeds.
Table 16. Supported cable distances by link speed
Cable type
OM3
OM2
OM1
Adapter LED
Green and yellow LEDs can be seen through openings in the mounting bracket of the adapter. Green
indicates firmware operation and yellow signifies port activity. Table 17 on page 69 summarizes the link
rate conditions. There is a one second pause when the LED is off between each group of fast flashes (2, 3,
or 4). Observe the LED sequence for several seconds to be sure that you have correctly identified the
state.
Table 17. Normal LED states
Green LED
Slow flashing
On
On
On
Power-on self test (POST) conditions and results are summarized in Table 18 on page 70. These states
can be used to identify abnormal states or problems. Follow the action to be taken for each condition.
2.125 Gbps
0.5 m - 500 m
0.5 m - 300 m
0.5 m - 150 m
Yellow LED
Off
2 fast flashes
3 fast flashes
4 fast flashes
4.25 Gbps
0.5 m - 380 m
0.5 m -150 m
0.5 m - 70 m
State
Normal, link inactive or not
started
2 Gbps link rate - normal, link
active
4 Gbps link rate - normal, link
active
8 Gbps link rate - normal, link
active
Managing PCIe adapters 69
8.5 Gbps
0.5 m - 150 m
0.5 m - 50 m
0.5 m - 21 m

Advertisement

Table of Contents
loading

Table of Contents