Packaging - KaVo SMARTmatic S80 K Instructions For Use Manual

(no validated cleaning of the interior in accordance with German RKI requirements)
KaVo recommends servicing the product as part of the reprocessing after each use,
i.e. after each cleaning, disinfection, and before each sterilisation.
▶ Remove the dental bur or diamond grinder.
▶ Service the product in the QUATTROcare PLUS.
See also:
2 Instructions for use KaVo QUATTROcare PLUS
Servicing the chuck
KaVo recommends cleaning and servicing the chuck system once a week using the
collet servicing program integrated in the device.
See also:
2 Instructions for use KaVo QUATTROcare PLUS
Note
Handpieces must be taken off the service couplings before the chuck service can
be started and performed.
▶ Close the front door and press the chuck service button for at least three seconds
until the spray canister control LED flashes three times consecutively.
ð
The device is in chuck service mode.
▶ Remove the service coupling of the chuck from the side hatch of the QUATTRO-
care PLUS and attach it to coupling service point four, on the far right. A MUL-
TIflex adaptor must be mounted there.
▶ Press the handpiece together with the guide bush of the chuck to be serviced
against the tip of the service coupling.
▶ Press the button marked with the chuck service symbol.
Note
Close the chuck service mode.
Option 1: Place the dental handpieces in the QUATTROcare PLUS 2124 A, close
the front door and start theservice procedure.
Option 2: After three minutes with no service procedure running, the device auto-
matically switches back to normal service mode.
See also:
2 Servicing with KaVo QUATTROcare PLUS

7.6 Packaging

Note
The sterilisation bag must be large enough for the handpiece so that the bag is not
stretched.
The quality and use of the sterilisation packaging must satisfy applicable standards
and be suitable for the sterilisation procedure!
Instructions for use SMARTmatic S80 K - 1.011.6771
7 Reprocessing steps in accordance with ISO 17664 | 7.6 Packaging
19 / 24