12 Removal, Replacement, And Addition Of Components - FLARM FUSION PowerFLARM User And Maintenance Manual

FLARM Technology Ltd
Hinterbergstrasse 15
CH-6330 Cham

12 Removal, Replacement, and Addition of components

System components may be removed and replaced following the instructions from
the respective manufacturer
disconnecting any component required for the operation of FLARM, the display (or
the location were the display was located if removing the display) must be
placarded with "FLARM INOP".
If the PowerFLARM Fusion is replaced, it must be updated to the latest firmware
version, or it must be ensured that a current firmware version is installed.
Configure the device as required during reinstallation. Always save the
configuration for documentation and future use. If not updating to the latest
firmware version, it must be ensured that the next annual maintenance is
completed before the firmware expires.
If the display is replaced, it must be configured e.g. for the correct baud rate. If
the display is replaced with a different model, PowerFLARM Fusion might have to
be reconfigured as well. If any replaced or newly installed display was/is able to
configure Fusion (e.g. as part of the start-up), ensure that all connected
components are configured and operate as required.
If any part of the system is modified (i.e. change, addition, or removal of
components), the Installation Verification Checklist in the Installation Manual must
be completed after the change, even if the modification is formally not a change
to the type certificate of the aircraft.
POWERFLARM
FUSION USER AND
MAINTENANCE
MANUAL
(e.g. Installation
Date: 2020-11-10
Version: 1.0
Page: 41 of 49
Document Number:
FTD-078
Manual). If removing or