11 Troubleshooting And Servicing Information - FLARM FUSION PowerFLARM User And Maintenance Manual

FLARM Technology Ltd
Hinterbergstrasse 15
CH-6330 Cham

11 Troubleshooting and Servicing Information

Many problems and issues can be related to one of the following causes:
Improper antennas or antenna cables used

Incorrect antenna or antenna cable installation

Incorrect configuration

Aging or breaking of components under normal or abnormal wear (device,

cables, antennas, connectors, connector pins)
Not using a FLARM Compatible display (no, incorrect, or incomplete collision

warnings, operation with error conditions, expired obstacle database, etc.)
No valid GNSS position (e.g. aircraft is inside a hangar)

Make sure all instructions have been followed. This includes the installation
instructions as well as other instructions.
A list of approved antennas and cables is available in the Installation Manual.
Configure the system using FLARM Hub (see Section 3.4 as well as Section 5).
Pay special attention to the 24-bit aircraft address, aircraft type, and
FLARM/ADS-B/SSR ranges and target processing settings.
A list of certified FLARM Compatible displays can be found in the Installation
Manual, as well as in the
If an error is indicated, a list of error codes can be found in Appendix B. Many
issues can also be resolved by consulting the FAQ:
https://support.flarm.com/
PowerFLARM Fusion may only be repaired by FLARM Technology Ltd or its
authorized service partners.
POWERFLARM
FUSION USER AND
MAINTENANCE
MANUAL
Product Selector under the category "Primary Displays".
Date: 2020-11-10
Version: 1.0
Page: 40 of 49
Document Number:
FTD-078