FLARM FUSION PowerFLARM User And Maintenance Manual page 13

FLARM Technology Ltd
Hinterbergstrasse 15
CH-6330 Cham
Bluetooth pairings

Obstacle database

CARP range analyzer data

Diagnostic log files

The firmware versions (PowerFLARM and Hub) do not change.
A factory reset should be applied under the following circumstances:
Installation in another aircraft and/or change of ownership

The Wi-Fi or device lock passwords have been lost

The device can be reset either via FLARM Hub (on the Tools / Support page) or by
using the hardware reset pin. To reset using the pin, push a paperclip or similar
into the hole next to the LED lights (see picture below) with the device OFF, until
the reset pin is pushed in. Hold the pin pushed in while powering on the device.
Hold the pin pushed in for at least 2 seconds and then withdraw the paperclip. The
device will revert to factory configuration during startup.
POWERFLARM
FUSION USER AND
MAINTENANCE
MANUAL
Date: 2020-11-10
Version: 1.0
Page: 13 of 49
Document Number:
FTD-078