Troubleshooting - Sharp DV-NC60W Operation Manual

Troubleshooting

The following problems do not always denote a broken this Unit. Perform the checks listed below before calling
service.
VCR/DVD
• No power
• The Remote does not work.
• No picture
• DEW
VCR
• VCR does not record.
• Cassette is automatically ejected
when pressing Æ Æ Æ Æ Æ REC or TIMER
ON/OFF.
• No colour or poor TV picture during
normal viewing.
• Snowy picture appears on TV during
playback.
• No tape movement.
• Cannot receive NTSC (M)
broadcasting.
• No picture appears or colour is not
correct during playback.
100
GB
DVNC60W(E)#100_105.pm6
Downloaded from: http://www.usersmanualguide.com/
Problem
• Is the power cord connected properly?
• Is the power cord firmly plugged into the power outlet?
• One of the safety mechanisms may be operating. In this event,
• Are the batteries loaded correctly?
• Are the batteries flat?
• Is the signal emitter on the Remote pointing at the Unit?
• Is the Remote too far from the Unit, or is there any obstacle between
• Did the VCR/DVD CHANGE Switch change correctly?
• Did the VCR/DVD SELECTOR change correctly?
• See page 2 for information (Condensation).
Problem
• Cassette erasure protection tab has been removed. Use a different
• Check if a cassette is loaded.
• Cassette erasure protection tab has been removed. Use a different
• Make sure all the cables are correctly connected.
• Make sure the Unit power cord is properly plugged in.
• Set the COLOUR MODE, NTSC MODE, and SYSTEM modes to
• Press CH ' / " to adjust the tracking or try a different cassette.
• The heads may be contaminated with condensed moisture or
• Make sure the Unit is not in pause/still mode.
• Make sure the tape has not reached the beginning or end.
• Make sure that the B/G, I, D/K, M (SYSTEM) setting is set to "M"
• Make sure the TV is set to the same channel as the Unit radio
• Check all connecting cables.
• Set the COLOUR MODE, NTSC MODE, and SYSTEM modes to
100
Suggested Solution
unplug the Unit from the power outlet briefly and then plug it in
again.
the Remote and the Unit?
Suggested Solution
cassette or place adhesive tape over the tab opening.
cassette or place adhesive tape over the tab opening.
match the broadcast system and TV.
magnetic coating from the video tape. (If this is the case, the
heads need to be cleaned. Ask the retailer or a Sharp approved
service centre.)
This Unit has a built-in full auto head cleaning mechanism,
however, there are some environments in which head cleaning
cannot be carried out completely.
when setting the channels.
frequency converter output channel adjuster (CHANNEL).
match the tape and TV.
01.11.14, 10:18 AM