Sharp DV-NC60W Operation Manual page 21

7
Press \ \ \ \ \ / | | | | | to select the RF output system that corresponds to
your TV by referring to the chart shown to the below, and press
SET.
8
Press OPERATE to turn on the power of the Unit. Select any
channel on the VCR tuner. If a picture appears and sound can
be heard, then the RF output system is correctly set. If a picture
appears but no sound can be heard, then perform step 7 above
to select another RF output system.
• Make sure the sound is not muted when checking the RF output
system.
• It is not necessary to change the system to RF system "M". The Unit
will automatically detect and change the RF system to "M" when
receiving the NTSC signal.
• If picture interference appears on the TV screen in step 6 above, you
can change the video channel (RF output channel from the Unit to TV)
with the following procedure. If UHF Channel (see Table 1) is an active
broadcast channel in your area, manually select a different channel
(UHF 21 to UHF 69) (see below) and then retune your TV as above.
1 Press OPERATE to turn off the power.
2 Keep pressing VCR MENU for more than two seconds to light up
the UHF Channel (see Table 1) on the VCR Front Panel display.
3 Press ' / " on the Remote to manually select an unused channel
for use as the video channel.
4 Perform steps 6 to 7 above using the newly selected video
channel.
5 Repeat steps 3–4 to select the optimal video channel.
DVNC60W(E)#014_020.pm6
Downloaded from: http://www.usersmanualguide.com/
I,B/G,D/K (RF system)
Hong Kong
China, Russia
Ex.
South East Asia
19
I
D/K
B/G
01.10.11, 9:19 am
Adjusting the Video Channel
TIMER
OPERATE
G-CODE EJECT
ON/OFF
ON VCR/DVD VCR MENU
DISPLAY
SCREEN SELECTOR DVD SETUP
FUNCTION PROG/ OPEN/
ZOOM
CONTROL REPEAT CLOSE
TITLE
DVD MENU
CLEAR SET
RETURN ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
AM/PM INPUT SELECT VCR DVD
/
REV FWD
PLAY
REC
PAUSE/STILL
STOP
TAPE DPSS
SKIP SLOW
SPEED
AUDIO
CH
OUTPUT
VCR DVD
VCR/DVD COMBINATION
19
GB