Kenwood DPX-4010 Instruction Manual page 34

Troubleshoot ing Guide
PROBLEM
The memory is erased w hen
the ignition is turned off.
A CD ejects as soon as it is
loaded.
The sound skips on a CD.
A track w ill not play.
The DSP effects are
imperceptible.
POSSIBLE CAUSE
The battery w ire has not been connected to the proper
terminal.
The ignition and battery w ire are incorrectly connected.
The CD is upside-dow n.
The CD is quite dirty.
The CD is scratched or dirty.
Random play has been selected.
You are using a tw o-speaker system.
The front and rear output are reversed.
The + and - of speakers are reversed.
The fader or balance settings are set all the w ay to one
side.
Connect the w ire correctly, referring to the section on
"Connecting Wires to Terminals".
Connect the w ire correctly, referring to the section on
"Connecting Wires to Terminals".
Load the CD w ith the labeled side up.
Clean the CD, referring to the section on "Cleaning CDs"
(see p. 6).
Clean the CD, referring to the section on "Cleaning CDs"
(see p. 6).
Turn off random play.
Use a front/rear four-speaker system.
Connect the w ire correctly, referring to the section on
"Connecting Wires to Terminals".
Connect the w ire correctly, referring to the section on
"Connecting Wires to Terminals".
Reset the fader or balance settings.
— 34 —
SOLUTION