Kenwood DPX-4010 Instruction Manual page 32

Inst allat ion (f or HON D A A CU RA Car)
Installation type 1
1
Use Accessory 1 to attach the
unit w hich w as assembled in
Assembly.
Accessory 1
(M 5 × 6 mm)
DPX-4010
N OTE
If accessories 6 and 7 hit the inside of the console, preventing
the unit from being attached tightly, snap their end parts off as
show n below .shipped w ith the unit, as show n above.
2CA U TION
Be careful not to get injured w ith the new edge.
2
Install the center panel
w ith the unit in your car.
N OTE
The illustration show s an
example of installation
using a vehicle bracket.
The shape of the bracket
varies w ith the vehicle to
be installed. Some bracket
requires three screw s
(Accessory 1 ) on each
side.
Accessory 67
— 32 —
Installation type 2
1
Attach Accessory 8 w hich
w as assembled in
Assembly.
Accessory 8 is to be fixed either
to the center or bottom,
depending on the car model.
Accessory 0
(M 5 × 6 mm)
DPX-4010
Accessory 8
Accessory 9
(M 3 × 6 mm)
Installation type 3
1
Attach Accessory @ to
Accessory 8 w hich w as
assembled in Assembly.
Accessory 0
(M 5 × 6 mm)
Accessory 8
DPX-4010
Accessory 9
Accessory !
(M 3 × 6 mm)
(M 5 × 10 mm)
Accessory @
2
Remove the factory-installed
car stereo and install the unit.
Factory-installed
car stereo
DPX-4010
Accessory !
(M 5 × 10 mm)
2
Remove the factory-installed
car stereo and install the unit.
Factory-installed
car stereo
DPX-4010
Reuse the screw s
that w ere removed.