Table of Contents
Advertisement
Release 08/2020 Ver. 1.0
6.2 Edge sensor Installation
The surface on which the edge sensor is mounted must be sound and reasonably flat. Note: Special
configurations of edge sensors, designed to be bent or contoured, can be addressed through Tapeswitch at
sales@tapeswitch.com.
6.2.2 Mounting guidelines
EDGE INSTALLATION PROCEDURE - Edge series configurations and single edge assemblies may be shipped
mostly assembled, in a crate. Some might be pre-drilled. Others need to be drilled on site, and attached to
equipment by the customer. The SIM should be mounted and electrically interfaced to the machine.
a. Remove all power to machine and SIM to prevent electric shocks.
b. Slide edges out of mounting channels (if applicable). See edge mounting channel options:
TAPESWITCH CORPORATION
100 Schmitt Boulevard
Farmingdale, New York, 11753
Installation Manual: Safety Edge
(Figure continued on next page)
© 2020 Tapeswitch Corporation. All Rights Reserved
11
Advertisement
Table of Contents
