Inserting And Removing A Mini Dv Cassette - Sharp VL-PD6H Operation Manual

Liquid crystal display camcorder
Hide thumbs Also See for VL-PD6H:
Table of Contents

Advertisement

VL-PD6H/009-018
Downloaded from:
http://www.usersmanualguide.com/
Inserting and Removing a
Mini DV Cassette
Inserting a Cassette
1
Supply power to the camcorder, then
slide the cassette compartment door
release and open the cassette
compartment door.
• A confirmation sound is made, and the
cassette holder extends and opens
automatically.
Cassette compartment
door release
Note: If the hand strap is pulled too tight, it
can obstruct the opening of the cassette
compartment door and the cassette holder
may be unable to extend. Should this occur,
loosen the hand strap and open the cassette
compartment door completely.
2
Insert the cassette fully with the window
facing outwards, and with the erasure
protect tab facing upwards.
Erasure
protect tab
12
3
Press the PUSH mark gently until the
cassette holder clicks into place.
• A confirmation sound is made, and the
cassette holder retracts automatically.
PUSH mark
4
Wait for the cassette holder to fully
retract. Close the compartment door by
pressing the centre until it clicks into
place.
Removing a Cassette
Perform step 1 above, then take out the
cassette.
Cautions:
• Do not try to close the cassette compartment
door while the cassette holder is extending or
retracting.
• Be careful not to get your fingers caught in the
cassette holder.
• Do not apply force to the cassette holder except
when pressing the PUSH mark to close it.
• Do not tilt the camcorder or hold it upside down
when you are inserting or removing a cassette. It
may damage the tape.
• Remove the cassette if you will not use the
camcorder for a long period of time.
• If you do not correctly close the cassette holder
in step 3, the camcorder's cassette protection
mechanism might eject the cassette. If this
happens, repeat the insertion procedure.
• Do not attempt to pick up the camcorder by the
cassette compartment door.
Notes:
• If the battery power is too low, you may not be
able to eject the cassette. Replace the battery
pack with a fully charged one.
• See page 95 for more information on the video
cassette tapes intended for use with this
camcorder.
01.4.24, 0:24 PM
12

Advertisement

Table of Contents
loading

Table of Contents