Table of Contents
Advertisement
Inlet strainer
FiguRe 10
9.
Properly install designed pipe supports and clamps. The scrubber, cylinder
and cooler connections may not be designed to adequately support the
piping.
lubricating oil Piping and Tubing
All frame lubricating oil piping and tubing should be made of stainless steel. All
electric motor driven compressors require a frame pre lube pump. (Does this go
here?) Design and install all compressor lubricating oil piping as follows:
1.
Thoroughly clean all oil piping internally of weld slag, mill scale and other
construction debris before installation.
2.
Clean the inside of all removed or replaced oil tubing, deburr its inside
diameter (ID) and blow clean any debris before re-installation.
3.
If using an electric or pneumatic motor driven oil pump, use stainless steel
pipe.
Packager installed instrumentation and fittings shall not
restrict oil flow to the compressor.
Complies with ANSI Z535, ISO 3864, OSHA 1910.145 (f) (9)
H301/302 HSR Compressors | Rev. 2.2 | 49
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
