Lubrication System; Cylinder Nameplates; Fi Gu Re 4 Cylinder Nameplate; Table 3 Lubrication System - GE H301 Series Operating Manual

24 | Chapter 3: General Data/Specifications

Lubrication System

H Frame series
Units of measure
Deliron cycle magnetic indicator torque
Divider block mount screw torque
H302 PRV cap-nut torque
Oil Sump capacity
Normal operation (hot)
Low oil pressure – Alarm
Low oil pressure – Shutdown
Normal operation (hot)
High oil temp – Shutdown
Minimum oil viscosity
Model
H302
* Maximum oil pump output flow is at the rated speed listed above, with a 160ºF (71ºC) oil temperature.
Table 3 Lubrication system

Cylinder Nameplates

The cylinder nameplate (Figure
number, bore (width of the inside of the cylinder) and the maximum allowable
working pressure (MAWP).
Cylinder nameplate
Fi gu Re 4
80 Inch-lbs. (1.7 N-m)
12 to 15 ft. lb. (16 to 20 N-m)
5.75 Gallon (21.77 Liter)
45 to 55 Psig (3.1 to 3.8 bar)
35 to 38 Psig (2.4 to 2.6 bar)
30 Psig (2.0 bar) falling
Fahrenheit (Celsius)
150 to 170ºF (65 to 76ºC)
20 cSt @ 175ºF (80ºC)
RPM Oil flow*
1,800 10 GPM (37.85 LPM)
4) is secured to the block and contains the serial
Inches (mm)
Foot Pounds (N-m)
15 Ft –lbs. (20 N-m)
Gallons (Liter)
Psig (bar)
185ºF (85ºC) rising
Oil heat rejection
5,000 BTU/Hour
(1260 Kilo-cal/Hour)