Advertisement
36
model no. 055-9035-4 | contact us 1-800-689-9928
FOR LITHIUM-ION BATTERY PACK STORAGE LONGER THAN 30 DAYS:
•
Store the lithium-ion battery pack where the temperature is below 26°C (79°F) and free of moisture.
•
Store lithium-ion battery packs in a 30–50% charged condition.
•
Every six months of storage, fully charge the lithium-ion battery pack.
•
Exterior may be cleaned with a cloth or soft non-metallic brush.
BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING
To preserve natural resources, please recycle or dispose of batteries properly. This product contains lithium-
ion batteries. Local, provincial, or federal laws may prohibit disposal of lithium-ion batteries in ordinary
trash. Consult your local waste authority for information regarding available recycling and/or disposal
options.
To ensure safety and reliability, all repairs should be performed by a qualified service technician.
WASTE DISPOSAL
The product must not be discarded with normal household waste. It must be disposed of properly.
WARNING!
• To avoid serious personal injury, always remove the battery pack from the tool when cleaning
or performing any maintenance.
• When servicing, use only identical replacement parts. Use of any other parts may create
a hazard or cause product damage. To ensure safety and reliability, all repairs should be
performed by a qualified service technician.
• It is not recommended to use compressed dry air to clean the tool. If cleaning with com-
pressed air is the only method available, always wear safety goggles or safety glasses with
side shields. If the operation is dusty, also wear a dust mask.
• Do not at any time allow brake fluids, gasoline, petroleum-based products, penetrating oils,
etc., to come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic
which may result in serious personal injury.
WARNING!
• Upon removal of the battery pack for disposal or recycling, cover the battery pack's terminals
with heavy-duty adhesive tape. Do not attempt to destroy or disassemble the battery pack or
remove any of its components. Lithium-ion batteries must be recycled or disposed of properly.
Also, never touch the terminals with metal objects and/or body parts as a short circuit may
result. Keep away from children. Failure to comply with these warnings could result in fire
and/or serious injury.
PROBLEM
PROBABLE CAUSE
Motor brake overheated from use
of defective or wrong size blade or
Brake does not stop blade
rapid ON/OFF cycling.
within 10 seconds
Arbour bolt is loose.
Battery not installed.
Motor does not start
Battery not charged.
Mitre table unlocked.
Angle of cut inaccurate
Too much sawdust under table.
Parts failure.
Pivot spring not replaced properly
Head assembly cannot
after service.
fully raise or blade guard
Sawdust build-up.
cannot fully close
Lock-down pin not set properly.
Improper operation.
Blade binds, jams or burns
Dull blade.
wood
Improper blade.
Warped blade.
Blade hits table
Misalignment.
Saw blade damaged.
Saw blade loose.
Saw vibrates or shakes
Saw not properly fastened down.
Workpiece not properly supported.
37
SUGGESTED CORRECTIVE
ACTION
Use a recommended blade.
Retighten.
Install the battery. Refer to INSTALL-
ING AND REMOVING BATTERY PACK.
Charge battery.
Rotate the mitre locking handle all
the way to the right.
Vacuum or blow out dust while
wearing eye protection.
Contact service centre.
Contact service centre.
Clean and lubricate moving parts.
Check, adjust and properly set saw-
head locking pin.
See OPERATING INSTRUCTIONS
section.
Replace or sharpen blade.
Replace blade.
Replace blade.
See "Assembly and adjustments"
section.
Replace blade.
Tighten black bolt.
Fasten saw to stand, bench or table.
Properly support or clamp
workpiece.
Advertisement
