As required by the relevant standards, the discontinuous measurement
8.9 Test Set up
(Click) test set up shall be the same adopted for continuous disturbances,
therefore, usually, a LISN is used to sample the RF signal to be measured.
In case the internal LISN is to be used, it is the one contained in the PMM
CA0010 Click Analyzer.
Please follow all the instructions illustrated in the CA0010 User's Manual to
assemble the correct setup for your test.
This is a Safety Class I apparatus and it is also equipped with a couple
of protective/functional earth terminals, both on the rear and front
panels. A good safety/functional ground connection should be
provided before to operate the analyzer.
8-8
Click Mode Operating Instructions