L3Harris NARDA PMM ER8000 User Manual page 73

8.1 Introduction
8.2 Click Mode
Option
8.3 Enter the Click Mode
Document ER8000EN-01101-1.00 - © NARDA 2020
8 - Click Mode Operating Instructions
(PMM CA0010 Option)
The CLICK mode allows the User to make in a fast, easy and fully
automatic way a difficult test like the Discontinuous Disturbances
measurement, as defined by current CISPR standards.
To enable the Click mode you need the optional PMM CA0010 Click
Analyzer.
For further information about Click Analysis and Generation software
installation and use, please refer to the "PMM CA0010 User's Manual".
When the Click option has been successfully installed, the PMM Click
Analysis software can be run to take measurements.
To enter Click Mode, run the PMM CA0010 Click Analysis software and
follow the instructions contained in the CA0010 User's Manual.
The main window will be the IDLE function, which allows a preliminary, free
running evaluation, at the selected frequency and level.
To increase test productivity the PMM ER8000 has some very unique
features: it allows skipping as many as 2 steps, as it may predict how many
clicks would overcome the Lq limit and may also advice the User if the next
step would fail.
PMM ER8000 works as a simultaneous 4 channels click meter.
Click Mode Operating Instructions 8-1