Table of Contents
Advertisement
N
Noise Amplification 33
O
Objective Lens 29, 35, 41
Opto-Electronics Module 29, 35, 41
Oscillation on the Analog Meter 32, 37
Output PCB 29, 35, 41
P
Pilot Monitor 11, 14, 17, 29, 31
Delay Adjust 34
Milliamp Output 34
Noise Amplification 33
Oscillation on the Analog Meter 32
Relay Contacts 33
Sighting 17
Start-up Checklist
Getting Started 31
System Gain/Climate Compensation 32
Power Connections 23
Power Fuse 47
Power Input 47
Powering with 115 Volts AC 25
Powering with 220/230 Volts AC 25
Powering with 24 Volts DC 25
Principle of Operation 13
Problem Isolation Checkout Procedure 47
Protective Ground Connection 24
Q
Quick Installation Procedure 14
R
Red/Green LED Indicators 37
Relay Contacts 13, 33, 39, 44
S
Service Markings 23
Service Request or Repair 9
Set-point 29, 35, 41, 44
Shipments to LumaSense for Repair 10
Sight Assessment 17
Sight Path and Optical Alignment 47
Sighting 17, 18
Signal I/O to Electronics 29, 35, 41
Signal Path 13
Smoke Monitor 11, 13, 18, 41, 43
Considerations 45
E
2
T QUASAR Flare Monitors Operation Manual
Delay Adjust 45
Initial control settings 44
Milliamp Output 45
Relay Contacts 44
Set-point 44
Sighting 18
Start-Up Operation Checklist 43
System Gain / Climate Compensation 44
Status Green LED 29, 35, 41
Status Red LED 29, 35, 41
Stopped Chopper Wheel 48
System Features 12
System Gain / Climate Compensation 32, 37,
44
System Gain Adjust 29, 35, 41
System Overview 11
T
Target Size and Focusing Range 20
Terminal Output PC Board 26
Troubleshooting 47
U
Unpacking and Inspection 8
V
Viewport Air Purge Requirements 20
Index • 72
Advertisement
Table of Contents
