Table of Contents
Advertisement
b. Connect the instrument loops and alarm outputs:
i. Connect the lines as needed for Normal Open (N.O.) or Normal Closed
ii. Connect the mA lines to the corresponding (MA-) and (MA+) outputs on
5. Proceed to the following chapters to complete the start-up checklist:
a. Chapter 5: Pilot Monitor (PM)
b. Chapter 6: Flare Monitor (FM)
c. Chapter 7: Smoke Monitor (SM)
E
T QUASAR Flare Monitors Operation Manual
2
Note: Secure power input lines together after connection to the
Terminal block to prevent an accidental hazardous live condition in the
unlikely event that a terminal screw becomes loose. Sleeve or tie
wrapping is acceptable.
(N.C.) relay to the corresponding locations on TB2.
TB2. Cable shield, if present, is NOT recommended to be connected to
the instrument.
Introduction • 15
Advertisement
Table of Contents
