Functional Modes - GE Druck TRX-II User Manual

# + EXE
Opens set-up menu.
Opens signal converter set-up screen.
• The RCL key + Numerical key 1-9
Recalls stored key-pad operations (Keystroking). Press RCL first
and hold, while pressing the next key.
• The 0 key
Changes the sign when display reads all zeros.
• The zero key
To reset the pressure sensor reading at zero. To reset counter/
totalizer function to zero.
• The info key
Give additional information at various menus. Calls the Help
screen.
• The key*
Press the light key to switch the back light ON or OFF.
* not applicable for Model TRX-II IS.
The following functions are only available with Software option.
• The Set-up key
Used to access the recording set-up.
• The As Fnd key
To start As Found calibration procedure.
• The Adjust key
To start adjust procedure.
• The As Left key
To start As Left calibration procedure.
• The View key
To view recorded calibration results.

Functional Modes

• Reading measure signals only
Leave the cursor at NONE in the source menu and select the
required measure function.
• Reading source signals only
Leave the cursor at NONE in the measure menu and select the
required source function.
• Simultaneous reading of measure and source signals
Select required measure and source functions. Menu selections
for both measure and source functions are made after each
other. After finishing all the selections for one function, the menu
prompts to proceed to the other function.
EN-4 K319 Issue 2