End Cover And P .C . Board Assembly - Assa Abloy Yale Delayed Egress Installation Instructions Manual

Delayed Egress
Exit Device
Installation Instructions
2

End Cover and P .C . Board Assembly

Figure 2
1-1/8"
(29)
®
Typical Mortise Cylinder
NOTE: • Use Yale
1-1/8" mortise cylinder
• For cylinders over 1-1/8",
use Yale
1. Trim device to proper length as required.
36" Exit Device - 1" maximum can be
trimmed
48" Exit Device - 6" maximum can be
trimmed
2. Carefully slide circuit board assembly into end
Cover to ensure indicator light (LED) is not
bent.
3. Insert mortise cylinder into end cover with
keyway horizontal, as shown.
4. Slide arming switch activator over mortise
cylinder so activator legs are on each side of
switch.
For technical support contact Yale at 800.438.1951 or support@yalelocks.com
®
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
An ASSA ABLOY Group brand
NOTE: Factory keyed orders will
be shipped assembled.
Cylinder Nut
Activator Legs
Arming Switch Activator
Order Separately
.742"
(18.9
1-1/2"
mm)
Dia
(38)
2160 Cam
1765 Series
Cylinder Collar
® 2153 x 2160 cam,
1765 Series cylinder ring.
®
Circuit Board Assembly
Indicator Light (
Lens Cover
Rear Cover End Cap
5. Insert flange of cylinder nut into arming
switch activator to allow rotation of
activator.
6. Tighten cylinder nut on mortise cylinder and
to secure circuit board assembly.
7. Verify assembly by rotating key counter
clockwise and clockwise. Key should move
freely and arming switch should trip for
both rotation directions. If key does not
rotate freely, verify cylinder nut was placed
in correct orientation. If arming switch does
not trip, activator legs on arming switch
activator can be bent to reduce or increase
rotational travel.
4
End Cover
Tabs
LED )
1765 Series
Cylinder Collar
(Order separately
when required)
1-1/8" (29)
Mortise Cylinder
with Yale 2160 Cam
(Order Separately)
®
80-9470-0162-000 10/18