Planar LookThru LO552 Series User Manual page 7

Command
reset(user) [CR]
aspect? [CR]
aspect# [CR]
aspect=fill [CR]
aspect=3 [CR]
brightness @@ [CR]
fake.command = 1 [CR]
brightness(zone.999) = 100
[CR]
brightness="new value" [CR]
model.id = 1 [CR]
display.name = "Name
containing \" and \\"
power.on.delay = .1
Planar LookThru Display Series RS232 User Manual
020-1381-00B
Response
RESET(USER)^NAK [CR]
ASPECT:AUTO [CR]
ASPECT:0 [CR]
ASPECT:FILL [CR]
ASPECT:3 [CR]
BRIGHTNESS!ERR 1 [CR]
FAKE.COMMAND:ERR 3 [CR]
BRIGHTNESS(ZONE.999)!ER
R 4 [CR]
BRIGHTNESS!ERR 5 [CR]
MODEL.ID!ERR 6 [CR]
DISPLAY.NAME:"Name
containing \" and \\"
POWER.ON.DELAY:0.1
Notes
Example action command that cannot
be processed at this time
The name for the Aspect Ratio setting
value is returned
The number for the Aspect Ratio setting
value is returned
Sets the Aspect Ratio to Fill
Also sets the Aspect Ratio to Fill
Example of an invalid syntax ("@@" isn't
a valid operator)
Example of an invalid opcode
("FAKE.COMMAND" doesn't exist)
Example of an invalid modifier
("ZONE.999" isn't a valid modifier for
"BRIGHTNESS")
Example of an invalid operand (the
Brightness command doesn't accept a
string operand)
Example of an invalid operator (cannot
write to this command)
The name will appear on the remote
monitor as Name containing " and \
Example of a fixed point operand. Sets
the Power On Delay to 0.1 seconds.
RS232 Protocol
Page | 7